19
ENGINE
When activated, after pressing ENTER, the number of wash engine related
to the required working mode from 1 to 15 is asked. See page 11 Engine
Programming.
When the required engine has been confirmed with ENTER, the screen
will display:
RMP
=
Enter
the
desired
value
and press ENTER to confirm.
NOTE: The input speed is the drum speed and depends on its technical
specifications (number of poles), the inverter adjustment and
the mechanical relationship between the engine and the drum
In PREWASH, WASH, RINSE and UNROLL cycles, the
maximum number of r.p.m can only be 100. In the SPIN cycle
the maximum number of r.p.m is preselected through the code
207
The activation of the drainage relay eliminates the display and this way avoids the possibility of
inserting relays for the filling of water, insertion of detergent and heating.
The sequence of the messages related to the outlets for the cycles PREWASH, WASH, RINSE,
UPWIND is the following one:
For EL6 with 16 outlets:
COOLING - LOAD BALANCED - DRAIN - COLD WATER- HOT WATER - HEATING -
DETERGENT 1 - DETERGENT 2 - DETERGENT 3 - DETERGENT 4 - HARD WATER -
RELAY 16 - RELAY 11 - RELAY 12 - RELAY 13 - MOTOR
2.- The cycle already exists:
The screen will display:
ALREADY
EXISTS
!
At this point, four options are possible:
a.-
Press STOP to choose another cycle.
b.-
Access the existing cycle by pressing ENTER Pressing INC and DEC all the scheduled
outlets for the first cycle will be suggested on the screen again and it will be possible to
modify the configuration, by pressing ENTER and RESET as already described above.
c.-
Insert one or more steps among the existing ones. Display the programme step by step
with the key ADVAN. The screen will display for 2 seconds the following message:
START STEP X
then:
ALREADY
EXISTS
!
Stop at the point where the display indicates the beginning of the step that is immediately
preceding the step to be inserted.
