47
The most likely causes in this case may be:
during the load phase:
1.-
Fault in the water inlet solenoid valve
2.-
There is no water in the supply line or the flow is very low.
3.-
The discharge valve could be clogged, open or closed.
4.-
Defective connection between the tub and the level sensor
In this case the operator can decide whether to continue with the process, with a reduced water
load, by pressing START, or stop the washing process by pressing RESET.
during the discharge phase:
1.-
Discharge valve clogged and closed
2.-
Discharge valve clogged
3.-
Discharge tub clogged
Press RESET to stop the programme.
OVERLOADED
it indicates an excessive heating in one of the engines.
Press the RESET key to stop the programme and let the engine cool down. If the indication occurs
again in the next washing process, technical service will be needed.
DOOR OPEN !
it indicates that the door has not been properly closed.
This indication inhibits the operation of the machine or overrides the programme.
To exit press EXIT
DRAIN
it indicates that when the engine of a slow or fast spin starts running, there are more than 2 cm of
water in the tub.
The machine will start from the beginning of the interrupted cycle as soon as the water level is
below 2 cm.
Press RESET to override the cycle or continue the programme.
