16
Example
:
PREWASH = n.
Enter the required number (between 1 and 99) followed by ENTER, two situations may occur:
1- The selected cycle does not exist in the memory and must be programmed.
2- The selected cycle already exists; in this case it can be displayed and edited.
1- The selected cycle does not exist:
the first step programming will be entered immediately and
will be displayed for 2 sec. as indicated below:
START STEP 1
followed by:
COOLING
?
NO
At this point, in step 1, it is defined if the cooling phase is activated or not, in this case press
ENTER and the message will be:
COOLING
?
YES
The 5 parameters to be programmed in order to activate the cooling phase will be displayed.
If you do not want to activate this phase, press INC; the following message will be displayed:
BAL. LOAD ? NO
In the step 1, you can define if you want to activate the compensated load phase or not.
If you want to activate this phase, press ENTER, to disable it, press RESET. The screen will
display:
BAL. LOAD ? YES
The 5 parameters to be programmed will be displayed to activate the phase of compensated load.
If you do not want to activate this phase, press INC; the following message will be displayed:
DRAIN ? NO
In step 1 you can define whether the outlet displayed by the screen is activated or not. Press
ENTER to activate the corresponding outlet.
When pressing INC and DEC all the available outlet will be displayed without altering the state.
When pressing ENTER or RESET the outlet state can be changed.
After having programmed all the outlets through the aforementioned procedure, you will display:
END OF STEP 1
Then you will be asked to define the cause to continue to the next STEP.
The possible causes are:
-
Water
level
-
Water
temperature
-
Time
Selecting one of the three with ENTER, you will be asked to define the value (in centimetres,
degrees or seconds) of the selected parameter.
