29
NOTE:
During the heating and load/discharge of water, the safety timer WDT is activated, which controls
the whole machine. If it reaches its time, an alarm message will be displayed on the screen,
indicating that some of the heating, load or discharge phases have not been completed within the
maximum allowed time.
SIMPLE CYCLE
The execution of a simple cycle is possible (pre-wash, wash or spin, etc.) by selecting the
programme n° 0.
The screen will display "Single cycle" then the choice of the desired cycle will be suggested. This
can be done by using INC or DEC keys, confirming the choice by pressing ENTER.
The number of the cycle must be entered ( WASH N° 3) confirming with ENTER.
When "RUN ?" is displayed, press the START key to begin with the machine cycle.
PARTIAL EXECUTION OF A PROGRAMME
The execution of a programme can be started in any intermediate cycle. After having chosen the
programme, at the moment "RUN?" is displayed, press ADVAN key: The cycles contained in the
programme will be displayed.
When pressing START in any of these intermediate cycles, the programme will start at this point,
not from the beginning.
DISPLAY THE CURRENT PROGRAMME NUMBER AND STEP
When pressing ENTER while a programme is being executed, the programme number and step
will be displayed
Example:
PRG 1 STP 3
PAUSE (SOAK)
It is possible to insert a pause in any moment of the washing process except in the distribution and
spin phases. Press PAUSE key. The duration of the pause will be displayed on the screen. Press
the START key to begin from the point at which it was stopped.
NOTE:
When pressing the PAUSE key, all the outlet relays are disabled leaving the discharge outlet relay
unchanged.
FAST FORWARD
During the execution of the programme, each time the ADVAN key is pressed the running step
finishes.
If this key is pressed while the slow or fast spin outlet is activated, the running spin cycle will be
overridden and a pause will be automatically inserted to stop the engine.
