8. Attach the Cable Tie Mount to the side of the Polishing Machine
Overarm with the #10-32 X 3/8 Button Head Screw using the
9/64” Hex L-Wrench. Route cable between side support and latch
pin cylinder air line. Secure the cable coming from the head with
the cable tie leaving slack to prevent pulling when the Polishers
Overarm is raised & lowered.
6. Reinstall the Micro-G® Head onto the
Mounting Plate with the four M3 X 8mm
Button Head Screws with the 5/64” or
2mm Hex L-Wrench. Lift overarm up to
the next lock position to easily place in
the screws.
46
7. Reinstall the Fixture Latching Rods through the Mounting Plate and
up into the Micro-G® Head. Secure with the mated Thumb Screw,
do not over tighten. The cross pin on the Latching Rod should be
parallel to the arm on the head of the Thumb Screw when
assembled.