c. Install the Fixture Latching Rods through
the Mounting Plate and up into the
Micro-G® Head. Secure with the mated
Thumb Screw, do not over tighten. The
cross pin on the Latching Rod should be
parallel to the arm on the head of the
Thumb Screw when assembled.
15. Load a Polishing Fixture with Retro-Fit Collar and secure with the
standard Fixture Screw. Rotate the Thumb Screws clockwise so
the cross pins on the Fixture Latching Rods goes in the Latch
Ring on the Polishing Fixture. Hold the Polishing Fixture up and
push down on the Thumb Screw
to engage the cross pin. Rotate
the Thumb Screws a quarter turn
clockwise to latch. Always rotate
the Thumb Screws clockwise
when latching or unlatching to
prevent the screws from
unthreading from the Latching
Rod.
Micro-G® Electrical Hardware Setup
Setup instructions to install the Micro-G® Electrical Assembly on an
APM-HDC-5400 Polishing Machine.
1. Remove the Micro-G® Electrical Assembly components from the
packaging.
a. Micro-G® Controller/Stepper Driver Board
b. AUX-1 stepper motor cable, 5 pin connector
c. AUX-2 position/home sensor cable, 7 pin connector
d. (2) #4-40 nuts
e. #8 external star washer
f. Two Cable Tie
49