9. When the F.C.I. count reaches the programmed F.C.I. interval, the
box will change to flashing
RED
with “Change Film”. THIS WILL
STOP THE MACHINE FROM POLISHING THE NEXT STEP
.
After changing the polishing film, press the
BLUE
“Reset” button
directly below the “Change Film.” This will reset the F.C.I. count to
zero, change to
BLUE
“Film OK” and allow the machine to polish
the next step.
10. The
BLUE
“Maint. OK” box will change to a
RED
“Need Maint.”
when the programmed maintenance values are reached. THIS
WILL NOT STOP THE MACHINE FROM POLISHING THE NEXT STEP.
11. After performing the required maintenance, reset the scheduled
maintenance by pressing the “System Config” tab at the top of
the screen. Select “Maintenance Schedule” from the drop down
box. Press the
RED
“Reset” button. This will reset the (Accum)
to “0” and on production screen it will change from
RED
“Maint.
needed” to
BLUE
“Maint. OK.”
12. Repeat steps 6 and 7 until the final step has been completed.
13. When the final step is complete, the screen will reset back to the
first step in the process.
Predefined Rework Start Step
If rework is required after the polishing process is complete, press
the “Rework” button in the “Step box.” The polishing process will
automatically take you to the predefined rework start step and
continue through each step until the final step in the process is
complete. Upon completion, the program will return to step #1.
Step Pause Button
If there is a need to stop the process mid-step, press the “Step
Pause” button on the right side of the front panel. This will
temporarily release the pressure, stop the rotation of the Platen, and
pause the time.
To restart the step at the exact point it was paused, press the
“Step Start” button.
38
