There are no user serviceable parts inside the machine
cabinet. Do not remove the sealed screws. Evidence of
tapering will void warranty.
Daily or More Often as Required
Polishing Fixtures
Although polishing fixtures manufactured by Domaille Engineering
are made of stainless steel, all traces of water and slurry should be
removed after each step in the polishing process. This will ensure
that the next step in the process is not contaminated by elements in
the previous process. Failure to do so may result in build up and/or
rusting of critical areas.
Polishing Machine
1. Clean the top of Platen, Overarm Top Plate, Overarm Rest Pad
and bottom of Overarm with a non-abrasive cloth with IPA and/or
Cotton swabs as needed. The accuracy of this machine is
dependent on keeping these areas clean.
2. Clean all residue, water and slurry from the top of the entire
machine and from the touchscreen panel cover. Do not
contaminate the touchscreen area.
WARNING: Do not use an air hose on or around the
Platen. This forces water and contaminates into the
wear surfaces and the mechanical drive unit,
potentially causing machine failure. Damage caused
by air hose use is not covered under warranty.
Monthly
Disconnect the polishing machine from the power source
before doing any maintenance work.
Polishing Machine Platen
The Platen should be removed and greased at least once a month.
If the machine is heavily used, more frequent greasing is required.
40