Dolmar SP-7650.4 R, Инструкция по эксплуатации

Страница: 12 / 264

12 13
4. Set two of 76 mm diameter bands (3) on the pipe loosely (those bands are used for
tightening the solution discharge lever and tube joint later).
Assemble the second nozzle (10) with straight pipe.
Tighten them with another 76 mm diameter band (3).
(10)
(3)
(3)
(3)
(11)
(12)
(9)
(1)
(2)
5. Put the solution discharge lever (9) onto the pipe.
Make sure that the open side of the lever’s base (11) faces the swivel pipe.
Align the lever’s base with the gap of the projection on the straight pipe (12).
Then tighten them with the 76 mm diameter bands (3).
6. Make sure all clamps are tight.
Adjusting and securing the control handle
1. Put the machine on your back and adjust the shoulder strap (see “Adjusting the
shoulder strap”).
2. Slide the control handle (1) along the tube to the most comfortable position.
3. Secure the control handle by turning the knob (2).
BEFORE STARTING THE ENGINE
1. Checking and refilling engine oil
1) Follow the procedure below when the engine oil is cold i.e. the mist blower has
not been running.
●
Inspection: Set the blower down on a level surface and remove the oil cap.
Verify that the oil level is within the upper (1) and lower (2) limit
marks on the oil level gauge (3). If the oil is not up to the 100 mL
level (4), fill up with new oil.
●
Adding oil: Set the mist blower down on a level surface and remove the oil
cap. Fill the oil up to the upper limit of the oil level gauge.
2) On average, engine oil normally needs to be added after every 20 hours of
operation. This interval for every change in oil corresponds to refueling the mist
blower approximately 10 – 15 times.
3) Please change the oil whenever it becomes dirty or significantly changes color.
(Refer to P. 22 for the oil change procedure and frequency.)
Recommended oil: DOLMAR genuine oil or SAE10W-30 oil of API type SF
grade or better (4-stroke motor oil for automobiles)
Oil capacity: Approximately 0.22 L (220 mL)
(3)
(1)
(4)
(2)
CAUTION:
●
If the mist blower is not stored in an upright position, the oil may flow from the level gauge into the engine and give a false reading when
checking the oil level. This may result in inadvertently overfilling whenever adding engine oil. Always store in an upright position.
●
If the upper oil level limit is exceeded, this can result in the oil becoming dirty and white smoke from burning excess oil.
Check Point #1: Concerning the oil cap when adding oil
●
Wipe off dirt and grime around the opening before removing the oil cap.
●
Remove the oil cap and place it on a clean surface so that it does not accumulate any sand, dirt, or other foreign bodies. These may stick to
the cap and adulterate the engine oil if proper care is not taken. Dirty oil containing sand, dirt, or foreign bodies may cause excessive wear on
the engine due to improper lubrication and result in a breakdown.