Docomo FOMA SH906i, Инструкция по эксплуатации

Страница: 63 / 596

e03_dv55_7e.fm
[61/84]
61
Continued on next page
Vo
ic
e/Vi
d
eop
ho
ne
C
al
ls
Calls may be interrupted even when the signal is strong (
]
appears) and you are not moving.
To call selecting a Multi Number
n
P. 435
To call selecting a phone number when the 2in1 is used
n
P. 436
1
In stand-by, enter a phone
number.
Always enter the area code even when the
number is in the same area.
Enter up to 80 digits.
To erase the last digit: Press
c
.
To erase all digits: Press
c
(for 1+
seconds).
2
Press
s
(Phone)/
i
(V.phone).
Unlike ordinary telephones, mobile phones send call tones in
short beeps before the standard ring tone.
When the other party is busy, there is a busy signal. Disconnect
and try again later.
Operation during a voice call
To display your own phone number: Press
C /
[Own number].
To enable/disable Hands-free: Press
s
(for 1+ seconds).
Operation during a Videophone call
To display your own phone number: Press
C /
[Own number].
To enable/disable Hands-free: Press
s
.
To switch between My side and Substitute image: Press
i
.
To set the light: Press
C /
[Videophone]
/
[Lighting]
/
select
the setting
/ t
.
3
Press
H
to end the call.
Making calls/Videophone calls
Note
When the 2in1 mode is set to [Dual mode], the screen for selecting
a phone number appears after step 2. Select the phone number
from [Number A]/[Number B].
Voice calls
Calls can be made even when steps 1 and 2 are reversed. If no
operations are performed for approximately 5 seconds after
entering the phone number, the call is made.
Videophone calls
A Videophone call is not connected when placed to an
unsupported handset. In addition, it is not connected to devices for
which 64K cannot be used due to network conditions.
If Call Waiting is subscribed to, the number is recorded in
Received calls and the stock icon
B
(missed call) appears when
a voice/Videophone call is received during a Videophone call.
When the sending/receiving of audio or video fails, the
Videophone call is not automatically restored. Make the
Videophone call again.
When the Videophone call does not connect
When the Videophone call does not connect, a message
explaining the reason appears. The other party’s actual conditions
may vary depending on the type of phone and network service
subscriptions.
[Check number, then redial]: A call is made to unused phone
number.
[Busy]: The other party is engaged in a call (The message may
appear during a packet transmission depending on the other
party’s terminal).
[Your call is being forwarded]: The other party’s handset is set
to forward Videophone calls.
[Out of service area/power off]: The other party is outside the
service area, or their mobile phone is turned off.
[Set caller ID to on]: Connected without notifying the caller ID
(When calling the visualnet, etc.).
dv55_E.book 61 ページ ２００８年５月６日 火曜日 午前８時５９分