Docomo FOMA SH906i, Инструкция по эксплуатации

Страница: 355 / 596

353
e16_dv55_7e.fm
[353/362]
D
ata Dis
p
lay/Ed
it/Ma
n
a
g
em
ent
Use the Ir exchange function from running software.
Activating i-
a
ppli from Ir exchange is also possible.
For details on activating Ir exchange from i-
a
ppli
n
P. 251
During Ir exchange, if a signal to activate i-
a
ppli is received from
devices supporting Ir exchange, software can be activated.
1
In the Custom menu, select [LifeKit]
/
[Receive Ir
data]
/
[Receive]
/
[Yes].
The FOMA terminal waits to receive data. Software is activated
when signal to activate i-
a
ppli is received from the sender’s
FOMA terminal.
Use the FOMA terminal’s Infrared port from i-
a
ppli software
to operate equipment supporting the infrared remote control
such as TVs and VCRs.
To use the infrared remote control function, download compatible
i-
a
ppli software.
Start i-
a
ppli software that supports Ir remote control functions, point
the FOMA terminal’s Ir port to the front of the remote control sensor on
the TV, VCR or other device to operate, and perform remote control
operations.
Actual operational methods will differ with each i-
a
ppli software application.
Control devices from a distance of up to approximately 4 m (Distance will
vary depending on the device, the ambient brightness and other factors).
Using Ir exchange with i-
a
ppli
software
Activating i-
a
ppli from Ir exchange
Note
When i-
a
ppli To is set to [No], i-
a
ppli is not activated from Ir
exchange.
Cannot be activated as i-
a
ppli stand-by.
Infrared remote control
Using the infrared remote control
function
Remote control operation
Note
When in the Self mode, the Ir remote control function cannot be
used.
Depending on the device, operation may not run properly.
Remote control operation may not run properly directly under
fluorescent lights, near other equipment using infrared signals, or
in areas of direct sunlight.
15°
Approx. 4 m
15°
Infrared port
dv55_E.book 353 ページ ２００８年５月６日 火曜日 午前８時５９分