Devolo dLAN 200 DSpro, Руководство пользователя

Страница: 9 / 82

|
Connection and Startup
9
|
devolo dLAN 200 DSpro Manual
|
If no device that is switched on (e.g. computer) is connected to the Ethernet port,
the dLAN 200 DSpro device switches to Power Save mode after about 20 minu-
tes (Power LED flashes). In Power Save mode, the dLAN 200 DSpro device can-
not be accessed via the power supply grid or the coaxial network. As soon as the
device that is connected to the Ethernet port is switched on again, your dLAN
200 DSpro is available again via the power supply grid or the coaxial network.
ETH 10/Act Lit steady when a 10 Mbps connection to the Ethernet network
exists; flashes when data is being transmitted.
ETH Col Flashes at a faster rate if the network is experiencing increasing
use.
ETH This is the connection point on the dLAN 200 DSpro for connec-
ting it to a computer or another device with the network cable
(included).
The Auto-MDI(X) interface in the dLAN 200 DSpro automati-
cally detects when a contact is seized and determines the trans-
mission rate of the connected network device.
Coax Here you connect the dLAN 200 DSpro to the coaxial connector
using the coaxial cable supplied.
Coax/Hybrid The switch must have been set to "Hybrid" to allow transmis-
sion across the power supply grid.
The switch must have been set to "Coax" to allow transmission
across the coaxial network.
AC Here you connect the dLAN 200 DSpro to the power supply
using the power cable (included).