Devolo dLAN 200 DSpro, Руководство пользователя

Страница: 56 / 82

Auto-configuration
|
|
devolo dLAN 200 DSpro Manual
|
56
쎲
STP_PTP_EXTA = [yes|no]
Configure the EXTA interface to be considered as point-to-point (by default
if connected through the backplane).
쎲
STP_PTP_EXTB = [yes|no]
Configure the EXTB interface to be considered as point-to-point (by default
if connected through the backplane).
12.8.4.12 MAC Ingress Filtering Parameters
쎲
MAC_INGRESS_FILTERING_ENABLE = [yes|no]
Enables the use of MAC ingress filtering. If enabled, the dLAN 200 DSpro
adapter filters by the source MAC address. If the source MAC of the frame
coming from Ethernet is not in the list, the frame is discarded. Default value:
no.
쎲
MAC_INGRESS_FILTERING_MAX_ALLOWED = [1-4]
Sets length of the MAC filtering ingress list. The maximum is 4 instead of 5
to allow the WISC MAC to be in the FW; this is done automatically. Default
value: 4.
쎲
MAC_INGRESS_FILTERING_MODE = [FIXED|AUTO]
쑗
If FIXED: Enables the INGRESS MAC FILTERING and registers the list of
MAC_INGRESS_FILTERING_FIXED_MAC (the following parameter) in
the list, up to the MAC_INGRESS_FILTERING_MAX_ALLOWED.
쑗
If AUTO: Deletes all MACs registered in the bridge associated to ETH
ports, and sets the AUTO flag. When the bridge receives a new MAC
coming from ETH, it registers it in the INGRESS_MAC_FILTERING list. If
the length of this list reaches the maximum allowed then it enables the
MAC_INGRESS_FILTERING.
쎲
MAC_INGRESS_FILTERING_FIXED_MAC.i = 0xXXXXXXXXXXXX
Only valid in FIXED mode, up to 4 MACs. If the MAX is set to lower than 4,
then only the first MACs until the length of MAX is completed are registered.
12.8.4.13 NTP Parameters
쎲
NTP_ENABLE = [enabled | disabled]
NTP feature enabled or disabled. Default value: enabled.
쎲
NTP_SERVER_IP = <ddd.ddd.ddd.ddd>
IP address of the NTP server.