10 - ELECTRICAL SYSTEM
229
ADJUSTING THE TIME
The time is adjusted as follows:
1. To display total kilometres
2. Press the “MODE” button for 3 seconds. The minutes indication will disappear
3. Press the “MODE” button to increase the hours until the desired hour is reached
4. Press the “MODE” button down for 3 seconds
5. Press the “MODE” button until the desired minutes are reached.
6. Press the “MODE” button down for 3 seconds to save the time data.
RESETTING THE TRIP METER VALUES
The trip meter values are reset by pressing the button down for 3 seconds with the LCD indicating the afore-
mentioned function.
USING THE CHRONOMETER
The machine is fitted with a chronometer that allows the measuring of 20 times performed by the machine in
motion, for example when timing laps on a circuit.
The measurement mode can be accessed only when the machine is in motion. By contrast, the viewing mode
can only be accessed when the machine is halted.
MEASURING THE TIME
To access the measurement mode, press the “MODE” button for 3 seconds with the machine running. The LCD
screen will indicate the number of times registered (“LAP”) and the chronometer will indicate zero.
Each time the button is pressed, the chronometer will register the time for the corresponding lap and begin the
timing of the next lap. The time achieved will be displayed on screen for 10 seconds. Each subsequent pressing
registers a time, until all the 20 laps available have been used up. If times continue to be measured, the chro-
nometer will revert to overwriting “LAP” 1.
The chronometer mode can only be exited with the machine halted.
VIEWING THE LAP TIMES
The lap times can only be viewed with the machine halted.
• Press the button until the chronometer function is reached, and then press down for 3 seconds to access
the chronometer function.
• Pressing the button will display the lap times registered.
RESETTING THE CHRONOMETER
The chronometer is reset in maximum speed mode. Press the button down for 3 seconds with the instrument
panel in maximum speed mode. The maximum speed and the chronometers will reset.
To once more measure lap times and access the measurement mode, the “MODE” button must be pressed
down for 3 seconds in chronometer mode with the machine running.
Warning: Avoid pressing the “MODE” button when the machine’s ignition is being turned on, or when the
instrument panel is performing its start-up check, to avoid entering workshop mode.
GEAR CHANGE INDICATION - PARAMETERS
The parameters are the following:
RPM MAX
11.500 RPM
RPM MIN
8000 RPM
RPM MAX
RPM MIN
Содержание GPR 125 Racing
