Derbi GPR 125 Racing, Руководство по ремонту

Страница: 11 / 247

1 - GENERAL INFORMATION
11
Replace all seals, retaining rings and O-rings when servicing the
engine. All surfaces receiving seals, retaining ring edges and O-
rings must be cleaned.
Apply oil to all paired parts and bearing during reassembly.
Apply grease to the retaining ring edges. After removing them,
replace all tab/spacer washers (1) and split pins. Bend the tabs
to fit the flat surfaces of the bolt or nut once they have been
tightened to the specified torque.
WHEN FITTING BEARINGS, EN-
SURE THAT THE SAME PRESSURE
IS APPLIED TO BOTH RACES TO
AVOID DAMAGING THEM.
Fit bearings and retaining rings in such a way that the manufac-
turers marks remain visible. On fitting retaining rings, applying
a thin film of light lithium soap based grease to their edges.
Where appropriate, apply oil generously when fitting bearings.
DO NOT USE COMPRESSED AIR
TO DRY BEARINGS. THIS WILL DA-
MAGE THE BEARING SURFACES.
Remove all the dirt, grime, dust and other foreign material befo-
re removing and dismantling.
N.B.
CAUTION
CAUTION