DataCard ImageCard Magna, Руководство пользователя

Страница: 27 / 180

Using the printer
2-9
User’s Guide for Magna™ Platinum Series™ Printers
4 Remove the end of the supply material from the empty supply spool if needed.
Dispose of the used supply according to your policy.
On a regular basis, such as weekly, use the cleaning pen to clean deposits
from the guides of the supply cartridge and clean the supply tracker.
5 Remove the empty spool from the holder and press it into place on the take-up
holder (step 1 in
Figure 2-11 ). Make sure the ribs inside the spool align with the
grooves in the holder.
6 Press on the spool and turn it slightly (if needed) until the spool fully covers the
ribs of the holder.
7 Unwrap the new supply material.
8 Place the full supply roll on the right holder as you face the open side of the
cartridge (step 2 in
Figure 2-11 ). Make sure the supply will unroll counterclockwise
, as shown.
Figure 2-11: Load supply in the cartridge
9 Make sure the ribs inside the spool align with the grooves in the holder. Press on
the spool and turn it slightly (if needed) until the spool fully covers the ribs.
10 Lift the label on the supply roll and unroll about 8 inches from the supply roll.
11 Wind the supply material in front of the guides and around the take-up spool (step
3 in Figure 2-11 ). Make sure that the material will wind counterclockwise .
12 Press the label onto the take-up spool to secure the supply material (step 4 in
Figure 2-11 ).
13 Press the spool caps back into position on the ends of the take-up spool and
supply roll (step 5 in Figure 2-11 ).
If you use an adjustable overlay cartridge, do not use spool caps. They
interfere with the operation of the adjustable overlay cartridge.
E
Take-up spool
Supply roll
5
1
4
3
2
Spool caps
Guides
E