Dannmar MB-240X, Инструкция по установке и эксплуатации

Страница: 43 / 60

MB-240X Wheel Balancer
43
P/N 5900262 — Rev. A1 — Jan. 2021
Maintenance
Make sure your Wheel Balancer is maintained on a regular basis.
Regular Maintenance
⚠
WARNING:
Disconnect the Power Cord from power before performing any
maintenance and take whatever steps are necessary to make sure the unit
cannot be re-energized until Maintenance is completed. Because the unit uses
electricity, you could be electrocuted or even killed if the unit is powered back on
during Maintenance.
To maintain your Wheel Balancer
:
• Daily : Make sure the unit is clean and dry before using it.
•
Weekly
: Make sure the alignment mark on the Shaft Assembly is correctly aligned with the Shaft
Housing and is securely tightened.
• Weekly : Unplug the Balancer to remove power. Clean the display with a rag. Do NOT soak the
unit with water.
• Monthly : Make sure all Anchor Bolts are tightened and secure.
• Monthly
:
Check all components to make sure they are in good operating condition. If you find a
component that is
not
working correctly, take the unit out of service and refer to
Troubleshooting for more information.
• Every three months : Check the Bolts on the components attached to the unit to make sure
they are tight and secure.
• Yearly : Have an Electrician come out and check the electronic components.
• Yearly : Take the unit out of service, disconnect the Power Cord from the power source, and then
thoroughly check and clean all components.
⚠
WARNING: Do not operate your Wheel Balancer if you find issues; instead, take the unit out of
service, then contact your dealer, visit Dannmar.com/support , or call (877)
432-6627 .