Dannmar MB-240X, Инструкция по установке и эксплуатации

Страница: 12 / 60

MB-240X Wheel Balancer
12
P/N 5900262 — Rev. A1 — Jan. 2021
Finding a Location
Keep in mind the following when deciding on a location:
•
Power source . The Balancer needs to be near an appropriate 110 or 220 VAC power source.
• Floor . The Balancer is best used on a flat, concrete floor. If the floor is not level or is unstable, the
Balancer will not return accurate test results.
• Accessibility . You need some space to move the Wheels you are going to balance to and from
the Balancer. Do not set up the Balancer in a well-travelled area.
•
No water
. The Balancer has electronic components. If the Balancer gets wet while turned on,
those electronic components will likely short circuit and have to be replaced.
⚠
WARNING Do not use the Balancer if it is sitting in water. You will almost certainly short circuit
the electronic components in the Balancer and you could electrocute yourself.
⚠
WARNING When a Wheel is spinning on the Balancer, you need to keep people away from it.
Do not touch the Rotating Wheel or Tire with your hand or body. Do not wear loose
clothing that can be caught up in the Wheel. Serious injury may result.
Clearances
For safety and to allow enough space to work with Wheels, a certain amount of clearance around the
Balancer is required.
Not drawn to scale. Figure above shown with optional Mounting Stand