Dannmar MB-240X, Инструкция по установке и эксплуатации

Страница: 21 / 60

MB-240X Wheel Balancer
21
P/N 5900262 — Rev. A1 — Jan. 2021
Voltage Switch Setting. The Voltage Switch (next to the on-off rocker switch) is set to the
110V setting. Refer to Figure D below.
If you want to connect the Wheel Balancer to a 110 VAC power source, simply verify the power switch
is set to 110 VAC and plug it in to a 110 VAC power outlet. No Electrician is needed to use the Wheel
Balancing Machine with a 110 VAC power source as shipped from the factory.
⚠
DANGER
All electrical work (including changing a Plug from 110 VAC to 220 VAC) must be
done by a licensed, certified Electrician. If you do not use a licensed, certified
Electrician, you void your warranty and put everyone who uses the Wheel Balancing
Machine in danger of injury or, in rare cases, death.
To convert the Wheel Balancing Machine to use a 220 VAC power source:
Make sure the Wheel Balancing Machine is disconnected from the power source .
If it is connected, disconnect it.
Do not begin to switch the Wheel Balancing Machine to
220 VAC until you are sure that power has been disconnected from the unit.
Have a licensed, certified Electrician cut off the 110 VAC plug on the end of the Power
Cord and attach a 250 VAC NEMA 30A, 2-Pole, 3-Wire plug. The MB-240X does not come with
this plug. You must supply your own.
Do not change the 110 VAC plug to a 220 VAC
plug unless you are a licensed, certified Electrician.
The colors of the three exposed wires from the power cord are Brown, Blue, and Green/Yellow,
the European color code.
Important : To connect the three exposed wires to an appropriate Plug or to hard-wire them,
have your Electrician follow the electrical codes for the country and locality in which
you are using the unit.
For example, if you are using the unit for 220V in the United States, the color codes of the power
cord wiring on the MB-240X correspond to:
Brown
: Live
Blue : Live
Green/Yellow : Ground
Fig. D