Dannmar MB-240X, Инструкция по установке и эксплуатации

Страница: 36 / 60

MB-240X Wheel Balancer
36
P/N 5900262 — Rev. A1 — Jan. 2021
⚠
WARNING
Do not attempt to stop a rotating Wheel with your hands. Always use the brake.
Even though there is no motor driving the Wheel it can severely injure you if it is in
motion.
When the Wheel stops, look at the values that appear in the Inner and Outer Windows on the
Display Panel; this is the unbalanced correction weight required for each plane measured in
ounces.
The value that appears in the Inner Window needs to be added to the
Inner Plane
of the Wheel.
The value that appears in the Outer Window needs to be added to the
Outer Plane
of the Wheel.
Turn the Wheel slowly to find the best location to put the weight on the
Inner Plane
. The Inner
Edge/Plane placement indicators located under the Inner Display Window light up or go out as you
move the Wheel to find the best location to put the weight.
When all the indicators on the Inner plane are lit, engage the brake to hold the Wheel and apply the
correct value weight to the inner plane of the Wheel at the 12 o’clock position. (If the Inner Display
Window shows
00 , do not add any weight to the Inner Edge).
Turn the Wheel slowly again to find the best location for the weight on the Outer Plane. The Outer
Edge/Plane placement indicators located under the Outer Display Window light up or go out as
you move the Wheel to find the best location to place the weight. When all the indicators on the
Outer Edge/Plane are lit, engage the brake to hold the Wheel and clamp the correct value weight
to the
Outer Plane
of the Wheel at the 12 o’clock position. (If the Outer Display Window shows
00 , do not add any weight to the Outer Plane).
Press S + R to reset the Balancer and test again using the same Wheel values and balance mode.
Spin the Wheel to test the balance again. The Wheel is balanced when both the Inner and Outer
Windows show
00 . It may take several attempts to get the imbalance to 0 .