Dannmar MB-240X, Инструкция по установке и эксплуатации

Страница: 30 / 60

MB-240X Wheel Balancer
30
P/N 5900262 — Rev. A1 — Jan. 2021
To mount a Wheel :
Make sure you are wearing ANSI-approved eye protection: safety glasses, face shield, or goggles.
Determine which mounting method you want to use.
Move the Wheel you are going to mount next to the Shaft.
Select the Mounting Cone that best fits the center hole of the Wheel.
If Rear-Cone or Dual-Cone Mounting, put the Spring and the desired Cone onto the Shaft.
Lift the Wheel and put it onto the Shaft, then slide it back towards the Shaft Flange.
You may need to lift the Wheel slightly when positioning a Cone in the center hole of the Wheel.
While holding the Wheel and other hardware in place, slide the Quick Nut over the Shaft while
holding the Red Quick-Release Levers next to the Wings.
Holding the Quick-Release Levers next to the Wings lets you Quickly slide the Quick Nut into
position near the Wheel.
Release the Quick-Release Levers.
Turn the Wings to fully tighten the Quick Nut, and thus the Wheel, in place.
You may want to spin the Wheel some as you tighten the Quick Nut; this can help you get a
strong, secure fit.
Important : Do not hammer or hit the Quick Nut to tighten it. You will damage the Quick Nut, which
is
not
covered under the Warranty.
Balancing Modes
Balancing Modes are based on the locations where the weight is applied:
•
Dynamic (DYN) . The default Balancing Mode when power is first applied to the Balancer.
Typically used with steel rims. If the Wheel is out of balance, weights are clamped on the Inner and
Outer Edges.
•
Static (STA)
. Used for older Wheels under 4 inches wide and motorcycle Wheels. Weight is
applied to the Center Plane only.