MB-240X Wheel Balancer
32
P/N 5900262 — Rev. A1 — Jan. 2021
⚠
CAUTION
Do not strike or drop Wheels onto Balancer the main shaft. Damage to the balance
sensors can result.
Dynamic Balancing
Upon first applying power to the Balancer the default balancing mode is the Dynamic mode. No
balance mode indicators are lit.
Dynamic Balancing balances a Wheel on both the Inner and Outer Edges.
If the Wheel is out of balance, a Clip-On Weight can be installed on either the Inner Edge, the Outer
Edge, or both.
To Balance a Wheel using Dynamic Mode
:
Make sure you are wearing ANSI-approved eye protection: safety glasses, face shield, or goggles.
Visually inspect the Balancer to make sure everything is in place.
Make sure the Wheel you want to balance is both clean and free of any weights that may have
been put on previously, then mount it.
Refer to
for mounting instructions, if needed.
Turn the Balancer Off and then back On, to reset it.
On power up,
USA 512
will appear in the Inner and Outer Windows, followed by default Wheel
dimensions.
Pull out the Inner Arm and place it against the Inner Edge of the Wheel (where the inner weight will
be installed) and hold it there; read the distance off the arm and enter this data into the Balancer
using the
Distance
+
/
—
key
.
-A-
will appear in the Inner Display Window and the distance value
will appear in the Outer Display Window
.
Measure the width of the Wheel using the Wheel caliper. Enter this width into the Balancer using
the
Width
+
/
—
keys.
-L-
will apear in the Inner Display Window and the value will appear in the
Outer Display Window.
Enter the Wheel diameter by reading the size off the Tire sidewall and enter this into the Balancer
using the
Diameter
+
/
—
keys.
-D-
will appear in the Inner Display Window and the diameter
value will appear in the Outer Display Window.
While facing the Wheel, start spinning the Wheel in a clockwise
direction. Begin by pushing the
Tire with your hand, then remove your hand from the Tire and turn the Quick Nut black handles to
increase the speed of rotation until the Outer Display Window reads
run.
⚠
WARNING
Do
not
attempt to stop a rotating Wheel with your hands. Always use the brake.
Even though there is no motor driving the Wheel it can severely injure you if it is in
motion.
Release the handle and wait. The display will go blank then the imbalance values will appear in the
Inner and Outer display windows.
Содержание MB-240X
