Dannmar MB-240X, Инструкция по установке и эксплуатации

Страница: 16 / 60

MB-240X Wheel Balancer
16
P/N 5900262 — Rev. A1 — Jan. 2021
Vacuum each hole clean.
Dannmar recommends using a vacuum to get the hole very clean.
Do
not
ream the hole. Do
not
make the hole any wider than the drill bit made it.
Make sure the Washer and Nut are in place, then insert the Anchor Bolt into the hole.
The Expansion Sleeve of the Anchor Bolt may prevent the Anchor Bolt from passing through the
hole in the Base Plate; this is normal. Use a hammer or mallet to get the Expansion Sleeve through
the Base Plate and into the hole.
Even using a hammer or mallet, the Anchor Bolt should only go into the hole part of the way; this is
normal. If the Anchor Bolt goes all the way in with little or no resistance, the hole is too wide.
Once past the hole in the Base Plate, the Anchor Bolt eventually stops going down into the hole as
the Expansion Sleeve contacts the sides of the hole; this is normal.
Hammer or mallet the Anchor Bolt the rest of the way down into the hole. Stop when the Washer is
snug against the Base Plate.
Wrench each Nut
clockwise
to the recommended torque of 55 lbf-ft./ 75 N-m. Wrenching the
Nut forces the Wedge up, forcing out the Expansion Sleeve and pressing it tightly against the
Concrete.
Important : Do
not
use an impact wrench to torque the Anchor Bolts.
Installing the MB-240X on the Tire Changer
The MB-240X is shipped with a Weldment Base Assembly for installation on the Dannmar DT-50
Series Tire Changer. The Base Assembly is a bolt-on addition to the DT-50 Tire Changer allowing the
Tire changing and balancing all in one location, saving space and time wasted in transporting the Tire
from changing to balancing stations.
Refer to
Figure B on the following page.
To install the MB-240X on the Tire Changer:
Install the Base Assy. Weldment (2) on the Tire Changer using the Hex Screws, and Lock Washer
provided (6)(5).
Secure the Balancer (1) on to the Weldment (2) using the M10 Screws (7) included.
Attach the tooling holder mounting plate (4) and cone hangers on the Weldment (2) using the
Screws provided.