MB-240X Wheel Balancer
28
P/N 5900262 — Rev. A1 — Jan. 2021
Inputting Measurement Data
•
Distance
. Pull out the Inner Measuring Arm until it touches the inner Wheel rim, note the value on
the Distance Ruler, and enter that value using the
Distance
+
and
—
buttons on the Control
Panel.
An
-A-
will appear in the Inner Display Window and the current value in the Outer Window.
•
Width
. Measure with the Wheel Calipers, then enter that value using the Width
+
and
—
buttons
on the Control Panel.
An
-L-
will appear in the Inner window and the current value in the Outer Window.
•
Diameter
. Read the value from the Tire sidewall, then enter that value using the
Diameter
+
and
—
buttons on the Control Panel.
A
-D-
will appear in the Inner window and the current value in the Outer Window.
Mounting a Wheel
The first step to balancing a Wheel is to mount it on the Shaft.
Important
: All Wheels should be mounted so that the inside (the side of the Wheel that goes
closest to the Vehicle) goes on the Shaft first.
There are three methods to mount a Wheel onto the Shaft:
•
Front-Cone Mounting
. The preferred method, as it generally produces the most accurate
balancing results. Refer to
Figure E
below.
An appropriately sized Mounting Cone goes on the Shaft after the Wheel, then the Quick Nut.
Fig. E
Содержание MB-240X
