Dannmar MB-240X, Инструкция по установке и эксплуатации

Страница: 26 / 60

MB-240X Wheel Balancer
26
P/N 5900262 — Rev. A1 — Jan. 2021
About Wheel Planes
If you were to split a Wheel down the center (as shown below), it would be split into two “Planes”, an
Inner Plane and an Outer Plane.
Balancing a Wheel on
both
planes at the same time is the most effective method. Of the five
Balancing Modes supported by the MB-240X, four of them balance on two planes at the same time.
The fifth mode, Static (STA) Mode , is included for older, thin, Automobile Wheels and Motorcycle
Wheels, which are not big enough to be balanced on both planes at the same time.
Because balancing a Wheel on both planes is so important to using the MB-240X, the Display Panel
shows a two-plane view of the Wheel being balanced.
The Inner Plane is the Tire side closest to the Balancer (the side of the Tire closest to the Vehicle) and
the Outer Plane is on the right (the side of the Tire furthest away from the Vehicle.)
The
INNER Window will display the correction weight to be place on either the Inner Edge or the Inner
Plane weight locations.
The
OUTER Window shows how much weight to place on either the Outer Edge or the Outer Plane
weight locations.
The weight placement Indicators, directly under the Inner and Outer Display Windows, all light up when
the best weight location is reached.