MB-240X Wheel Balancer
33
P/N 5900262 — Rev. A1 — Jan. 2021
Once the values appear in the display windows, pull the brake against the Tire to stop the rotation.
When the Wheel stops, look at the values that appear in the Inner and Outer Windows on the
Display Panel; this is the unbalanced correction weight required for each plane measured in grams.
The value that appears in the Inner Window needs to be clipped to the Inner Edge of the Wheel.
The value that appears in the Outer Window needs to be clipped to the Outer Edge of the Wheel.
Turn the Wheel slowly to find the best location to put the weight on the
Inner Edge
. The Inner
Edge/Plane placement indicators located under the Inner Display Window light up or go out as you
move the Wheel to find the best location to put the weight. When all the indicators on the Inner
plane are lit, engage the brake to hold the Wheel and clamp the correct value weight to the inner
edge of the Wheel at the 12 o’clock position. (If the Inner Display Window shows
00
, do not add
any weight to the Inner Edge).
Turn the Wheel slowly again to find the best location for the weight on the
Outer Edge
. The Outer
Edge/Plane placement indicators located under the Outer Display Window light up or go out as
you move the Wheel to find the best location to put the weight. When all the indicators on the
Outer Edge/Plane are lit, engage the brake to hold the Wheel and clamp the correct value weight
to the outer edge of the Wheel at the 12 o’clock position. (If the Outer Display Window shows
00
,
do not add any weight to the Inner Edge).
Press
S + R
to reset the Balancer and test again using the same Wheel values and balance mode.
Repeat the process, spin the Wheel again. The Wheel is balanced when both the Inner and Outer
Windows show
00
. It may take several attempts to get the imbalance to 0.
Static Balancing
Static Balancing is for older Wheels under 4 inches wide and motorcycle Wheels.
If the Wheel is out of balance, weight goes on the Center Plane when using Static Mode.
To Balance a Wheel using Static Mode
:
Make sure you are wearing ANSI-approved eye protection: safety glasses, face shield, or goggles.
Visually inspect the Balancer to make sure everything is in place.
Mount the Wheel you want to balance. Verify the Wheel is clean and remove any weights from
previous balancing.
Refer to
Содержание MB-240X
