Dannmar MB-240X, Инструкция по установке и эксплуатации

Страница: 20 / 60

MB-240X Wheel Balancer
20
P/N 5900262 — Rev. A1 — Jan. 2021
Installing the Shaft
The Shaft holds the Wheels to be balanced.
Tip Consider having two people on hand to install the Shaft: one person to hold the Shaft
Assembly in place while the second person Screws in the Mounting Bolt. Also, consider
having some rags nearby as the Shaft is greased to protect it.
To install the Shaft
:
Locate the Shaft Assembly and the M14 x 240 mm SCHS Mounting Bolt from the parts supplied
with the Balancer.
Carefully clean the threaded shaft and the center hole of the housing using alcohol or equal.
Have a second person hold the shaft housing while you put the Shaft Assembly into place next to
the housing and hold it there.
Put the M14 x 240 mm SCHS Mounting Bolt into the end of the Threaded Shaft and begin
tightening it with a 10 mm hex key.
Before fully tightening
the Mounting Bolt, make sure the Alignment Marks are aligned (see
drawing below).
Not necessarily to scale. Not all components shown.
Tighten the Mounting Bolt into place.
Connecting to Power
The Wheel Balancing Machine comes configured for a 110 VAC power source.
⚠
DANGER This Wheel Balancing Machine uses electrical energy. If your organization has
Lockout/Tag-out policies, implement them once the unit is connected to power.
The Wheel Balancing Machine comes configured for a 110 VAC power source. It may be converted to
function with 220 VAC, if desired.
Plug. The Power Cord has a 110 VAC three prong plug.