![background image](http://html1.mh-extra.com/html/dannmar/mb-240x/mb-240x_installation-and-operation-manual_3431293025.webp)
MB-240X Wheel Balancer
25
P/N 5900262 — Rev. A1 — Jan. 2021
Window. When all of the indicators are lit, hold the Wheel in place using the brake. Place the
correction weight at 12 o’clock dead center on the outer edge/plane of the Wheel.
•
Balancing Mode indicators
. Select the Balancing mode by pushing the
F
key. The indicator
will light next to the balancing mode selected. Modes available are
Dynamic, Static, ALU 1,
ALU 2, and ALU 3.
The red marks indicate the position plane for the correction weight.
Available weight locations:
⚠
CAUTION
Never use tools or
anything sharp to press the keys
on the Balancer. Damage to the
switch and display membrane will
occur.
•
Distance
.
-A-
is displayed in the
Inner Display Window
. Used to enter the inside distance
between the side of the Balancer and the inside edge/plane of the Wheel. Value is displayed in the
Outer Display Window. Press
+
and
—
to increase and decrease the value.
•
Width
. An
-B-
is displayed in the
Inner Display Window
.
Used to manually enter the Width of
the Wheel. Press
+
and
—
to increase and decrease the value. This value is displayed in the
Outer Display Window
and is measured by the Wheel Caliper supplied with the Balancer.
•
Diameter
.
-A-
is displayed in the
Inner Display Window
. Used to manually enter the
Diameter
of the Wheel. Press
+
and
—
to increase and decrease the value. This value is
displayed in the
Outer Display Window
and is read off the Tire sidewall.
•
S Key
.
Combination Function Key.
•
F Key
.
Selects balancing modes.
•
R Key
.
Combination function and reset key. Push once to revise distance, width or diameter
inputs.
•
C Key
.
Displays imbalances of <5g.
Combination key inputs:
S + R keys
Resets the Balancer to run the
same test mode using the same
Wheel data again.
S + F keys
Displays the last completed test
and balance mode.
S + F keys
Hold the keys down until the
Wheel position indicators stop
flashing (about 5 seconds) then
release.
S + (Distance
+
) +
(Distance
—
)
Shifts weight units between grams
/ ounces.
Содержание MB-240X
