Daikin FDMR50TVMG, Руководство по обслуживанию

Страница: 159 / 224

SiSG121917E Troubleshooting for Outdoor Unit
Part 6 Service Diagnosis 154
Reference
Reference
7.13 High Pressure Control in Cooling
Error Code
F6
Outdoor Unit LED
Display
A j 1 i 2 h 3 i 4 i 5 h
Method of Error
Detection
High-pressure control (operation halt, frequency drop, etc.) is activated in cooling operation if
the temperature sensed by the outdoor heat exchanger thermistor exceeds the limit.
Error Decision
Conditions
 The temperature sensed by the outdoor heat exchanger thermistor rises above about 65°C.
 The error is cleared when the temperature drops below about 50°C.
Supposed
Causes
 Installation space not large enough
 Dirty outdoor heat exchanger
 Defective outdoor fan motor
 Defective stop valve
 Defective electronic expansion valve or coil
 Defective outdoor heat exchanger thermistor
 Defective outdoor unit PCB
Troubleshooting
Check No.01 Refer to P.169
Check No.12 Refer to P.172
(R2041 8 )
Caution
Replace the o u tdoor fan
motor.
Reconnect the connector or
fan motor lead
w ires.
Replace the stop v al v e.
Replace the o u tdoor heat
exchanger thermistor.
Replace the o u tdoor u nit
PCB (main PCB).
Replace the electronic
expansion
v al v e or the coil.
Replace the o u tdoor u nit
PCB (main PCB).
Change the installation
location or direction.
Clean the o
u tdoor heat
exchanger.
Check the installation space.
N G
OK
OK
N G
N G
OK
OK
OK
N G
N G
Check No. 19
Check the o u tdoor fan.
Check No. 18
Check the discharge
press u re.
Check No. 12
Check the electronic
expansion v al v e.
Check No. 17
Check the installation
condition.
Be s u re to t u rn off the po w er s w itch b efore connecting or disconnecting
connectors, or parts may b e damaged.
Check No. 01
Check the o u tdoor heat
exchanger thermistor.