xStack
®
DES-3810 Series Layer 3 Managed Ethernet Switch Web UI Reference Guide
247
Destination IP Address
Enter the destination IP address used here.
Destination IP Address
Mask
Select and enter the destination IP address mask used here.
DSCP
Enter the DSCP value used here.
ICMP
Select this option to specify that the rule will be applied to ICMP traffic.
Type
– Enter the ICMP packet type value used here.
Code
– Enter the ICMP code value used here.
Action
Select
Permit
to specify that the packets that match the access profile are forwarded by
the Switch, according to any additional rule added (see below).
Select
Deny
to specify that the packets that match the access profile are not forwarded by
the Switch and will be filtered.
Select
Mirror
to specify that packets that match the access profile are mirrored to a port
defined in the config mirror port command. Port Mirroring must be enabled and a target
port must be set.
Priority (0-7)
Tick the corresponding check box if you want to re-write the 802.1p default priority of a
packet to the value entered in the Priority field, which meets the criteria specified
previously in this command, before forwarding it on to the specified CoS queue.
Otherwise, a packet will have its incoming 802.1p user priority re-written to its original
value before being forwarded by the Switch.
For more information on priority queues, CoS queues and mapping for 802.1p, see the
QoS section of this manual.
Replace Priority
Tick this check box to replace the Priority value in the adjacent field.
Replace DSCP (0-63)
Select this option to instruct the Switch to replace the DSCP value (in a packet that meets
the selected criteria) with the value entered in the adjacent field. When an ACL rule is
added to change both the priority and DSCP of an IPv4 packet, only one of them can be
modified due to a chip limitation. Currently the priority is changed when both the priority
and DSCP are set to be modified.
Replace ToS
Precedence (0-7)
Specify that the IP precedence of the outgoing packet is changed with the new value. If
used without an action priority, the packet is sent to the default TC.
Time Range Name
Tick the check box and enter the name of the Time Range settings that has been
previously configured in the
Time Range
Settings
window. This will set specific times
when this access rule will be implemented on the Switch.
Counter
Here the user can select the counter. By checking the counter, the administrator can see
how many times that the rule was hit.
Ports
Enter the list of ports, used for this configuration, here.
VLAN Name
Specify the VLAN name to apply to the access rule.
VLAN ID
Specify the VLAN ID to apply to the access rule.
Click the
Apply
button to accept the changes made.
Click the
<<Back
button to discard the changes made and return to the previous page.
After clicking the
Show Details
button in the
Access Rule List
, the following page will appear:
Содержание xStack DES-3810
Страница 1: ......
