15
2.4 Privileged Mode
The only place where you can enter the Privileged (Enable) Mode is in User Mode. When you
successfully enter Enable mode, the prompt will be changed to ICPE# (the model name of your device
together with a pound sign). Enter the question mark (?) or help command to view a list of commands
available for use.
Command
Description
copy-cfg
Restore or backup configuration file via FTP or TFTP server.
disable
Exit Enable Mode and return to User Mode
exit
Exit Enable Mode and return to User Mode.
firmware
Upgrade Firmware via FTP or TFTP server.
help
Display a list of available commands in Enable Mode.
history
Show commands that have been used.
logout
Logout from the Gateway Controller.
ping
Used to test the reachability of a host on an Internet Protocol (IP) network
reload
Restart the Gateway Controller.
write
Save your configurations to Flash.
configure
Enter Global Configuration mode
show
Show a list of commands or show the current setting of each listed command.
2.4.1 Copy-cfg Command
Use “copy-cfg” command to backup a configuration file via FTP or TFTP server or restore the
Gateway Controller back to the defaults or to the defaults without changing IP configurations.
1.
Restore a configuration file via FTP or TFTP server.
Command
Parameter
Description
ICPE# copy-cfg from
ftp [A.B.C.D] [file
name] [user_name]
[password]
[A.B.C.D]
Enter the IP address of your FTP server.
[file_name]
Enter the configuration file name that you want to
restore.
[user_name]
Enter the username for FTP server login.
[password]
Enter the password for FTP server login.
ICPE# copy-cfg from
tftp [A.B.C.D]
[file_name]
[A.B.C.D]
Enter the IP address of your TFTP server.
[file_name]
Enter the configuration file name that you want to
restore.
Example
ICPE# copy-cfg from ftp 192.168.1.198 HS_0600_file.conf misadmin1 abcxyz
ICPE# copy-cfg from tftp 192.168.1.198 HS_0600_file.conf
2.
Restore the Gateway Controller back to default settings.
Command / Example
ICPE# copy-cfg from default
NOTE:
There are two ways to set the Gateway Controller back to the factory default settings. Users
can use the “copy-cfg from default” command in CLI or simply press the “Reset Button” located on
the front panel to restore the device back to the initial state.
