SMI21
98
12.1.7.4. Type 2 "
Outputs
" Tab Parameters
Setting the parameters of PWM output 1 "Real speed": The parameters can be set for the signal frequency of
this output (must be identical to the one for PWM output 2).
If cyclical ratio = 0%
→ Real speed = 0 rpm.
If cyclical ratio = 100%
→ Real speed = 4000 rpm.
Figure
146
Setting the parameters of PWM output 2 "Real torque": The parameters can be set for the signal frequency
of this output (must be identical to the one for PWM output 1) and the torque value corresponding to a
cyclical ratio of 100% (scaling).
If cyclical ratio = 0%
→ Torque supplied = 0 mNm.
If cyclical ratio = 100%
→ Torque supplied = "S2 torque".
Figure
147
State of digital output 3 "Motor running": Used to find out whether the motor is stopped or running.
Figure
148
State of digital output 4 "Error": Used to find out whether an error has been detected.
Figure
149
