Configuration and Setup
3-26
If your network does not support DHCP:
1. Get the values
IP Address, Subnet Mask and Gateway Address
from your network administrator.
2. Use the arrow button up or down
until the display window shows
DHCP Setup
and confirm
with
to move the
“
>
”
marker down change the setting.
3. Use arrows down/up
to select
NO and c
onfirm with
Enter
.
The scanner will then be
identified on the network with the values you enter manually in the next steps. .
4. Use the arrow buttons up/down
until the iJET Panel displays
IP Address
and confirm with
Enter
.
5. The default IP shows 4 groups with 3 digits in each group. Use the arrows up/down
to change
the first group (3 digits). Press
to move to the next 3 digit group and again the arrows to
change them. Continue with each group until you have the right IP displayed and press
Enter
to
confirm.
6. Use the arrow buttons arrow buttons up/down
until the iJET Panel displays
Subnet Mask
and
confirm with
Enter
.
Subnet Mask
is a mask used to determine what subnet an IP address belongs
to. Use the up/down arrow to change a digit
’
s value in the same manner as described above for the
IP Address. Confirm with
Enter
7. Use the arrow buttons arrow buttons up/down
until the iJET Panel displays
Gateway Address
and confirm with
Enter
. A
Gateway address
is the IP address of a network point that acts as an
entrance to another network. Use the up/down arrow to change a digit
’
s value in the same manner
as described above for the IP Address. Confirm with
Enter
Use the arrows to change the IP
values as described above.
IP Address
> xxx.xxx.xxx.xxx
Enter
Enter
Change value to
“
NO
”
and confirm with
Enter
DHCP Setup
> NO
Press
Enter
to confirm DHCP
setup
>
DHCP Setup
YES
Enter
