Condair DL II, Руководство по эксплуатации

Страница: 76 / 80

76 Product specification
Condair DL
Type A
( with booster pump)
Type B
( without booster pump)
Sound level
Sound level approx. 51 dB(A) approx. 41 dB(A)
Hygiene
Silver ionization cartridge "Hygiene Plus" Yes
Communication
Remote operating and fault indication Yes
Modbus RTU and Modbus TCP Yes
BACnet IP and BACnet MS/TP Master or
Slave Mode
Yes
IoT Yes
Interfaces
Ethernet Yes
USB Yes
RS 485 Yes
Air
Pressure drop (393 ft/min (2 m/s)) approx. 0.16" w.c. (40 Pa)
Max. air velocity 492.13 ft/min (2.5 m/s) (without droplet separator),
787.40 ft/min (4 m/s) (with droplet separator)
Air filter quality before humidification unit MERV13 or better
Max. admissible air temperature 140 °F (60°C) (before humidification unit)
Water
Connector water supply ø0.47" (ø12 mm) plug-in coupling or 1/2" male thread adapter (supplied)
Connector water drain ø0.39" (ø10 mm) plug-in coupling or 1/2" male thread adapter (supplied)
Admissible water supply pressure working pressure
43.51 ... 101.5 psi (3 ... 7 bar)
working pressure
43.51 ... 101.5 psi (3 ... 7 bar)
Admissible water temperature 41 ... 68 °F (5 ... 20 °C)
Water quality requirements fully demineralised water from reverse osmosis system with 0.5...15 µS/cm
( without any additives ), max. 100 cfu/ml
Operating monitoring RO water min. pressure, max. pressure, pressure after sterile filter, conductivity
Ambient conditions operation
Admissible ambient temperature 41 ... 104 °F (5 ... 40 °C)
Admissible ambient humidity 10 ... 80 %rh, non-condensing
Ambient conditions storage
Admissible ambient temperature 41 ... 104 °F (5 ... 40 °C)
Admissible ambient humidity 10 ... 75 %rh, non-condensing
Protection class
Control unit IP21
Central unit IP21
Certificates
Certificates CE, DGUV, EAC, BTL
1)
Larger installation length on demand
2)
Larger dimensions on demand
3)
Larger capacities on demand (consider possible number of steps for capacity range!)
Note: For systems "Type A" (with booster pump), the minimum output of 11.02 lb/hr (5 kg/hr) can only be regulated at a flow
pressure <58.0 psi (<4.0 bar). With a flow pressure of ≥58.0 psi (≥4.0 bar), we recommend a minimum output of 22.04 lb/hr
(10 kg/hr) for "Type A" systems.
4)
The nominal control accuracy may not always be available, because various factors (temperature control, water recycling,
flap valve systems, etc.) may affect the accuracy.
5)
These values can be smaller influenced by other limit values such as humidity, volume flow or air speed! The values are to be
understood as theoretical appoximate values, which are determined by the number of nozzles and their size. The maximum
capacity values are achieved only with a booster pump.