Condair DL II, Руководство по эксплуатации, Страница: 23 / 80

23 Operation
4.4.5 Wash over of the ceramic plates
The ceramic wash over function is only accessible if the ceramic wash over function has been activated
in the control software (see Section 5.3.3.5 ).
CAUTION!
During the ceramic wash over the nozzles spray water onto the ceramic plates, similar to when 100%
demand is present. In systems with a booster pump, this also switches on.
This process must be monitored by the operator since the humidity can significantly exceed the desired
setpoint. Over-saturation of the ceramic plates is likely.
After the ceramic wash over is complete, any water behind the ceramic plates must be removed if it
cannot drain from there.
Note: if an error message is active flushing of the ceramic plates is not possible.
To perform a flushing of the ceramic plates, proceed as follows:
09/01/2021 DL
07:00 pm
Manual Functions
Flushing
Ceramic Wash Over
09/01/2021 DL
07:00 pm
Home
Next Maintenance
1685 hr
Demand
Standby
0%
09/01/2021 DL
07:00 pm
Ceramic Wash Over
Manual Functions
Back Continue
09/01/2021 DL
07:00 pm
Ceramic Wash Over
60 %
In Progress
Cancel
1 2 3 4
1. Press on the <Manual Functions> button in the home screen (1).
2. The "Manual Functions" submenu (2) appears. Here, press on the <Ceramic Wash Over> button.
3. The ceramic plate flushing confirmation display appears. Here, press on the
<Continue> button to
start the flushing of the ceramic plate.
Note: When the ceramic wash over is started, all spray valves open for the set spray time (see Sec-
tion 5.3.3.5 ) and spray water onto the ceramic elements as with a 100% demand. In systems with
a booster pump, the booster pump is also activated with the set pressure (see Section 5.3.3.5 ).
4. The flushing progress display appears (4) and shows the current status of the ceramic plate flushing
cycle. After flushing cycle has finished the home screen is shown again.
In order to stop the ceramic plate flushing cycle, press the
<Cancel> button in the flushing progress
window. The flushing cycle is stopped, and the home screen is shown again.