Condair DL II, Руководство по эксплуатации

Страница: 55 / 80

55 Maintenance and Replacement of components
6.4.3 Removal and installation of the nozzle support
Fig. 12: Removal and installation of the nozzle support
Removal of the nozzle support
1. Remove nozzle"A" together with the O-ring "B" as described in Section 6.4.2 .
2. Remove coloured ring "D" from the nozzle support.
3. Remove the hose(s) from the nozzle support (press the locking ring towards screw, then pull hose
off).
4. Remove connection nipple (press the locking ring towards screw, then pull off nipple).
5. Squeeze the catch locks of the nozzle support and remove the support.
Note: prior to the removal note the orientation of the nozzle support (straight, to the left, etc.).
Installation of the nozzle support
1. Before installation, check all parts (including O-rings) for any damage. Damaged parts must be
replaced .
Important! Before installation, flush water conduits with RO water.
2. The installation follows the reverse order of the removal.
– Make sure the nozzle support is installed in the nozzle grid on the right place and with the correct
orientation.
– Following installation verify correct fastening of all hose connectors. Correctly mounted hoses
cannot be removed without pressing the locking ring.
A B D