Condair DL II, Руководство по эксплуатации, Страница: 37 / 80

37 Operating the Condair DL control software
5.3.2.7 View operating states in the submenu "Diagnostics> Input Diagnostics"
09/01/2021 DL
07:00 pm
Humidity Control
Safety Loop
Enable Humidification
FC Error
Water Conductivity
PS2 Pressure Switch
24V Ext. Supply
5V Per. Supply
Ag-Ion Current
PS5 Nozzle Pressure
Disinfection Tank Level
Leak Monitoring
10V Ext. Supply
CS1 Contact
Water Temperature
PS4 Inlet Pressure
Pump Current
CS1 Contact
0.5 V
Closed
Off
Off
5 µS/cm
On
23.8 V
4.9 V
0.2 mA
58.0 psi
Off
Off
9.8 V
Off
50.0 °F
58.0 psi
0.0 A
Off
Input Diagnostics
– Humidity Control: Shows the applied voltage signal at the input signal
terminal "X16" between "HUM" and "GND".
– Safety Loop: Shows the current status of the safety loop.
– Enable Humidification: Enable signal present at X16 or not (Remote
enable).
– FC Error: Is "On" when FC is switched on and no error is present. Contact
drops out when the FC is switched off or there is an error at the FC.
– CS1 Contact: Status of the input for flushings.
– PS2 Pressure switch: Status of the pressure switch PS2 for sterile filter
(only for systems with a sterile filter and pump).
– PS4 Inlet Pressure: Analog input of pressure sensor PS4 (inlet pressure).
–
PS5 Nozzle Pressure:
Analog input of pressure sensor PS5 (nozzle
pressure).
– Pump Current: Current power consumption of the pump motor.
– Water Conductivity: Current conductivity of the inlet water in μS/cm.
– Water Temperature: Current temperature of the inlet water in °F.
–
Ag-Ion Current:
Currently measured current of the silver ionization.
– Disinfection Tank Level: Current level of the disinfection tank.
– Leak Monitoring: Current status of the leak monitoring.
– 24V Ext. Supply: Effective voltage of the 24 V DC supply.
– 10V Ext. Supply: Effective voltage of the 10 V DC supply.
– 5V Per. Supply: Effective voltage of the 5 V DC supply.