Condair DL II, Руководство по эксплуатации

Страница: 43 / 80

43 Operating the Condair DL control software
– Lower Limit Hum. : With this setting you set the minimum signal value
in % of the maximum signal value of the humidity sensor, if undershot a
sensor interruption message (Error "E32") is triggered.
Note : this setting appears only if the "Control Mode" is set to "RH P" or
"RH PI".
Factory setting:
3 %
Options: 0.0 ... 10.0 %
– Enable Contact : With this setting you determine whether the enable
contact on the driver board is evaluated ("On") or ignored ("Off") by the
control software.
Factory setting:
On
Options:
On
or
Off
5.3.5 Communication settings in the "Network" submenu
In the "Network" submenu you determine the parameters for digital communication protocols.
5.3.5.1 Accessing the "Network"submenu
Access the "Network" submenu as shown below.
Network
Maintenance
Features
Controls
09/01/2021 DL
07:00 pm
Menu
09/01/2021 DL
07:00 pm
Home
Next Maintenance
1685 hr
Demand
Standby
0%
09/01/2021 DL
07:00 pm
1001
Password
1 2 3
4 5 6
7 8 9
0
****
Password: "8808"
Remote Fault Indication
IP Settings
IoT Settings
Modbus Settings
BACnet Settings
09/01/2021 DL
07:00 pm
Network