4-20
Diagnostic Tools
■
Diskette drives
■
Fixed disks
■
Serial interfaces
■
Installed Compaq devices (tape drive, SCSI device, or network status)
To run TEST:
NOTE: You must create a diagnostics diskette before you can run TEST.
1.
Restart the workstation from the diagnostics diskette you have created.
2.
Press Enter to bypass the welcome screen.
3.
Select Computer Checkup (TEST).
4.
Select the option to view the device list. A list of installed hardware devices is
displayed.
5.
Verify that TEST correctly detected the devices installed. If the list is correct, select
OK. The test option menu is displayed again. If the list is incorrect, be sure that any
new devices are installed properly.
NOTE: This utility may not detect non-Compaq devices.
6.
Select one of the following from the TEST option menu:
■
Quick Check Diagnostics
■
Automatic Diagnostics
■
Prompted Diagnostics
CAUTION: If attended testing is selected, the test itself may result in data loss.
IMPORTANT: When you run the TEST utility, be sure to record any error message
numbers.
7.
Follow the instructions on the screen as the diagnostic tests are run on the devices.
When the testing is complete, the TEST option menu is displayed again.
8.
To exit TEST, press ESC until you see the Exit option, then press Enter.
