3-21
Compaq Professional Workstation AP200 Maintenance and Service Guide
Graphics Controller Memory
To remove a memory module on the graphics controller:
CAUTION: Before removing the access panel, ensure that the workstation is
turned off, all cables are disconnected from the back of the workstation, and the
power cord is disconnected from the grounded AC outlet.
1.
Perform the service preparations shown on page 3-2.
2.
Remove the access panel.
3.
Disconnect any cables from the graphics controller.
4.
Remove the retaining screw that secures the graphics controller.
5.
Hold the graphics controller at each end and carefully pull up until the connectors pull
free from the slot.
6.
Place the graphics controller on a flat, grounded service, then pull up
1 and out 2 on
the memory module.
1
2
Figure 3-24. Removing a graphics controller memory module
To reinsert the memory module, be sure the memory module notch lines up with the tab in the
socket at a 30 degree angle, then lower the module until it latches into position.
