3-17
Compaq Professional Workstation AP200 Maintenance and Service Guide
Drivelock
The workstation chassis has drivelocks that secure the drives in both the minitower and
desktop configurations.
NOTE: In the illustration below, drivelock
2
is the only drivelock you need to press when
removing and replacing mass storage devices. Drivelock
1
is automatically engaged when
drivelock
2
is pressed.
2
1
Figure 3-19. Drivelock positions
To remove the drivelocks:
CAUTION: Before removing the access panel, ensure that the workstation is
turned off, all cables are disconnected from the back of the workstation, and the
power cord is disconnected from the grounded AC outlet.
1.
Perform the service preparations shown on page 3-2.
2.
Remove the access panel.
3.
Remove the front bezel.
4.
Remove all drives from the computer.
5.
Lift up on the side of each drivelock nearest you and push them toward the front of the
drive cage
1, then snap the tabs out of the holes in the drive cage 2.
CAUTION: The spring under the drivelock may pop out unexpectedly.
