Digital fire detection control panel
LYON REMOTE PLUS
96
FIRE PROTECTION MANUFACTURER
C / Compositor Wagner, 8 –P.I. Can Jardí 08191 - RUBÍ (Barcelona) ESPAÑA.
Tlf.: +34 935 862 690 –
L o o p
0 0 1
P o i n t 0 0 3
A 3 0 X H A
L o o p
:
0 0 1
P u n t o :
0 0 1
S . N u m b . :
2 9 1 8 4
T e m p . :
[ 0 2 4
0 2 4
0 2 4
0 2 5 ]
V a l u e s
:
- - -
D i r t
- - -
A v e r a g e :
0 2 4
S e n s i t i v : H I G
Check that the information shown is correct.
With the (
) arrow keys, it is possible to change from one point to another.
With the (
) arrow keys, it is possible to change from one loop to another
5. -Configure Zones
When an incident is detected by the control unit, pressing the (
) key will display the label of the zone to which
point belongs.
A L A R M S
C :
L :
P t :
0 1 > Z : 0 0 1
C E N T R A L
H A L L
0 1
0 1
0 0 6
< < 0 1
∕ 0 2
The purpose of an alarm zone is to provide more complete information and to achieve greater speed when
locating an element with an alarm. The aim of a zone is to group together sensors that are located in the same
area.
In order to configure alarm zones, it is necessary to follow the following steps:
Menu (access code 27)
4.
System configuration (access code 9000)
2
Configure
3
Configure Alarm
Zones.
You will be asked for the number of the zone to configure. Enter the number and the following menu will appear:
By selecting option
1
Configure Zone
the option will be the first to appear. Confirm with the
ENTER
key.
Important: 8 possible lists are available for each zone. Firstly, you will be asked for the loop and number of the
first point. Secondly, you will be asked for the last point number for the list. Always confirm with the ENTER key.
Once configuration of the zone is complete, it is important to view the zone configuration using option 5 in order
to check it has been configured correctly.
In order to give a name to a zone, you must select option
4-Labelling
, confirming with the
ENTER
key. Within
this option, select the character (letter or number) using the up and down arrow keys and change position in the
label using the left and right cursors arrow keys. Save the label using the
ENTER
key.
