COBHAM Sea Tel Tracker 6000, Руководство по установке

Страница: 22 / 53

Sea Tel Tracker 6000 Installation
7. Assure that the bottom flange of the panels are sitting down level on the concrete.
Apply caulking to mating flange of panels 201 & 202. Apply Loctite to the exposed
threads of the bolts and tighten to torque spec from the bottom of the vertical flange
to the top. Wipe off the excess caulking from inside and outside of these panels.
Repeat with flange 202-203, 203-204, 204-205, 205-206 & 206-207.
8. Repeat step 6 to mount panels 208-211. Install a lifting strap on the bottom bolt
between panels 207 & 208 and 210 & 211.
9. Apply a bead of caulking to the bottom of the top flange of the cap. Set the cap into
the opening in to top of the upper panels. Align the mounting holes and loosely install
the mounting bolts and washers. Apply Loctite to the exposed threads of the bolts and
tighten to torque spec the bolts. Wipe off the excess caulking from inside and outside
of the cap.
10. Apply a bead of caulking to the vertical sides of panel 212. With someone inside put
panel 212 in place, align the mounting holes and loosely install the mounting bolts and
washers. Apply Loctite to the exposed threads of the bolts and tighten to torque spec
the bolts starting from the cap and then down both sides from the top to the bottom.
Wipe off the excess caulking from inside and outside of the cap and panel.
11. Attach a 4-part lifting sling to the lifting straps.
12. Using a suitably rated derrick or crane, lift the top section of the radome about 6 feet
to allow installation of the third layer of the radome under the top section.
3.3.7. Assembling the Third Layer of the Radome
With the top section of the radome suspended, start assembling the third layer panels (serial
numbers ending with 301-312) of the radome by bolting them to each other and to the
panels above. They are numbered to assure that they are assembled in the correct order
(301 is mounted to the bottom of 201, etc).
1. Set panel 301 in place under 201 and loosely install the horizontal flange mounting
bolts and washers. Apply Loctite to the exposed threads of the bolts, and with the
flange open apply a bead of caulking between the panels. Assure that panel 301 is
centered on panel 201 and tighten to torque spec the bolts. Wipe off the excess
caulking from inside and outside of the panel flange.
3‐6
EAR Controlled - ECCN EAR99