COBHAM Sea Tel Tracker 6000, Руководство по установке

Страница: 18 / 53

Sea Tel Tracker 6000 Installation
You can change order of these steps; however, in the end the objective is to have a well
sealed radome with flanges that well aligned and are clean of excess caulking.
3.3. Preparing Location for the Out Door Unit (ODU)
3.3.1. Lay Out ODU Mounting Holes
The first step is to lay out the holes in the concrete pad for the base of the pedestal and the
bottom of the fiberglass radome to be bolted down onto.
Refer to drawing 94-163300-A SITE ARRANGEMENT, RADOME PAD, 8.0M, LEO for the
mounting hole pattern and relation to true North.
 The hole pattern of the Pedestal Base MUST be oriented to true North.
 The hole pattern of the Radome Panels MUST be oriented for the entry door to be
South, or other desired position relative to true North.
Refer to drawing 97-168704_A01 8M RADOME HOLE MARKING JIG to fabricate a jig for
marking the radome mounting hole pattern.
Refer to drawing 99-169359-A T6000 Antenna and Radome Mounting Hole Layout
Instructions;
 Locate Center of Installation and True North
During the planning process you will have determined the location for the T6000
antenna, HVAC and radome. Locating the center point of the antenna and radome is
a critical first step in laying out all the fastening locations.

Mounting Holes Related to Center
When completed you will have marked 8 holes for the antenna pedestal and 96 holes
for the radome. Both sets of holes depend on center location. Once center is
located drill a
∅
5/16” hole 2 inches deep in mounting surface for a 1/4-20 female
threaded anchor.
3.3.2. Open General Assembly Crate
Move the crate to a location that will not interfere with assembling the ODU. Inventory &
Stage components
3‐2
EAR Controlled - ECCN EAR99
1. Remove the side panel