Club Car FE 350, Дополнение к руководству по обслуживанию и ремонту

Страница: 96 / 280

11
Test Procedures TROUBLESHOOTING AND ELECTRICAL SYSTEM
2m
20
m
200
m
2k
200
200
200 200
20
2
200
m
500
20k
200k
2000
k
1000
OFF
WAVETEK 5XL
V
V
V
A
! !
COM 200nA
MAX
1000 ---
750V
FUSED
200 OHM SETTING
Some wires
removed for clarity.
10
1414
Figure 11-55 Brake Light Relay Coil Test
14. If a problem was not detected in the previous steps, check the following items:
– Battery voltage. See Test Procedure 1 – Battery on page 11-17.
– Continuity of all ground terminal block wires. See Test Procedure 10 – Wire Continuity on page 11-27.
– Taillight sockets. See Test Procedure 37 – Taillight Bulb Socket on page 11-56.
– Check taillight bulbs for continuity.
– Brake pedal limit switch. See Test Procedure 39 – Brake Pedal Limit Switch on page 11-56.
– Park brake pedal limit switch. See Test Procedure 38 – Park Brake Limit Switch on page 11-56.
–
For Turf 2 vehicle:
– Check the continuity of the yellow wire from the inline fuse holder to the light switch.
– Check the continuity of the fuse in the inline fuse holder on the yellow wire connected to the large post of
the solenoid.
For Turf 6, Carryall 6, TransPorter, Villager 6, and Villager 8 vehicles:
– Check the continuity of the red wire from the fuse block to the large post of the solenoid.
– Check the continuity of the accessory fuse (located in the fuse block).
Page 11-54 2009 FE 350 Maintenance and Service Supplement