Club Car FE 350, Дополнение к руководству по обслуживанию и ремонту

Страница: 141 / 280

ELECTRICAL COMPONENTS Horn
12
HORN
See General Warning on page 10-1.
TESTING THE HORN
See Test Procedure 40 – Voltage at Horn on page 11-57.
HORN REMOVAL
1. Disconnect battery and spark plug wire(s). See Disconnecting the Battery – Gasoline Vehicles, Section 10,
Page 10-2.
2. Remove the center dash panel. See Key Switch Removal, Section 12, Page 12-14.
3. Disconnect the orange wire (1) from the horn (2) (Figure 12-45, Page 12-41) . Do not allow wire to touch the frame.
4. Remove the hex nut (3), lock washer (4) and the black wire (5) from the mounting stud on the front of the horn.
5. Remove the horn from the vehicle.
HORN INSTALLATION
1. Install the orange wire onto the horn. Slip the black wire ring terminal onto the mounting stud.
2. Install the horn stud through the mounting bracket (6). Install the lock washer and nut onto the mounting stud to
tighten the horn to 8 ft-lb. (10.8 N·m)
(Figure 12-45, Page 12-41) .
NOTE: Shoulder on nut fits into hole in mounting bracket.
3. Connect battery and spark plug wire(s). See Connecting the Battery – Gasoline Vehicles, Section 10, Page
10-3.
6
5
4
3
2
1
3
2
1
1434
Figure 12-45 Horn Assembly
1435
Figure 12-46 Horn Switch Assembly
2009 FE 350 Maintenance and Service Supplement Page 12-41