Club Car FE 350, Дополнение к руководству по обслуживанию и ремонту

Страница: 268 / 280

19
Driven Clutch TORQUE CONVERTER
DRIVEN CLUTCH
See General Warning on page 10-1.
DRIVEN CLUTCH REMOVAL
1. Remove the drive belt as instructed. See Drive Belt Removal on page 19-3.
2. Remove the bolt (11) and mounting washer (12) from the clutch shaft (Figure 19-17, Page 19-14) .
3. Grasp the driven clutch assembly and slide it off the shaft.
4. Leave the key (9) in the keyway.
DRIVEN CLUTCH DISASSEMBLY
1. Using external snap ring pliers, remove the retaining ring (4) (Figure 19-15, Page 19-13) . See following
WARNING.
WARNING
• Do not place fingers under the cam when removing the cam. The moveable face may spin when the
cam buttons release from the cam ramps, resulting in severe personal injury.
2. Insert a puller plug (2) (CCI P/N 1014507) (Figure 19-16, Page 19-13) into the shaft bore and use a driven clutch
cam puller (1) (CCI P/N 1014508) to remove the cam (3) from the fixed face shaft (Figure 19-17, Page 19-14) .
3. Remove the spring (5) (Figure 19-17, Page 19-14) .
4. Retain the key (3).
5. Slide the moveable face (7) off the fixed face shaft (8).
Page 19-12 2009 FE 350 Maintenance and Service Supplement