Club Car FE 350, Дополнение к руководству по обслуживанию и ремонту

Страница: 78 / 280

11
Test Procedures TROUBLESHOOTING AND ELECTRICAL SYSTEM
2m
20
m
200
m
2k
200
200
200 200
20
2
200
m
500
20k
200k
2000
k
1000
OFF
WAVETEK 5XL
V
V
V
A
! !
COM
200nA
MAX
1000 ---
750V
FUSED
2
1
3
1. 20k Ohm Setting 2. Core 3. Spark Plug Wire
475
Figure 11-37 Secondary Coil Resistance – Bench Test
3.2. If the resistance is between 12.0k - 14.0k ohms, the secondary coil and spark plug cap are within acceptable
limits; proceed to step 6 on page 12-26. If the resistance is not between 12.0k - 14.0k ohms, the spark plug
cap and secondary coil must be tested independently from each other.
4. If not previously tested, test the spark plug cap separately from the secondary coil.
4.1. Remove the rubber gasket (1) on the plug cap (2) by rolling back the gasket onto the spark plug wire (3)
(Figure 11-31, Page 11-33) .
4.2. Remove the cap from the wire by turning the cap counterclockwise three or four revolutions while gently
pulling it off the wire (Figure 11-32, Page 11-33) .
4.3. Using a multimeter set to 20k ohms, place the red (+) probe of the multimeter into the end of the spark plug
cap that normally connects to the spark plug and place the black (–) probe into the end of the cap with the
internal screw
(Figure 11-33, Page 11-33) . If the resistance is not between 4.5k - 6.0k ohms, the cap has
failed and must be replaced. Proceed to the next step with the spark plug cap still removed.
5. Test the secondary coil separately from the spark plug cap.
5.1. Using a multimeter set to 20k ohms, place the red (+) probe of the meter into the end of the spark plug wire
(3) and place the black (–) probe on the core (2) (Figure 11-37, Page 11-36) . If the resistance is between
6.0k - 11.0k ohms, the secondary coil is within acceptable limits. If the resistance is not between 6.0k -
11.0k ohms, the ignition coil has failed and must be replaced.
6. If the preceding tests indicate that the ignition coil resistance readings are within acceptable ranges, but the coil
fails to function properly, replace the ignition coil and cap.
7. Connect battery and spark plug wire(s). See Connecting the Battery – Gasoline Vehicles, Section 10, Page
10-3.
Page 11-36 2009 FE 350 Maintenance and Service Supplement