Club Car FE 350, Дополнение к руководству по обслуживанию и ремонту

Страница: 104 / 280

12
Starter/Generator ELECTRICAL COMPONENTS
2. To prevent contact between the brushes and commutator as the commutator is installed, and possible damage to
the brushes, lift the brush springs out of the notches in the brushes and pull the brushes back from the center of
the commutator end cover. The springs will rest on the sides of the brushes and help prevent them from sliding
towards the center of the cover
(Figure 12-6, Page 12-4) .
3. Install the commutator end cover (23) onto the armature shaft. Align the locating pin with the pin hole in the cover.
Install two M6 x 180 mm bolts (20) and tighten to 100 in-lb (11.3 N·m)
(Figure 12-2, Page 12-2) .
4. Push the brushes down into the holders. Position springs into the notches in the brushes. Install the brush cover
(30) that has the drain hole in it next to the A2 terminal. Install the remaining three brush covers (29) in the
openings in the commutator end cover (23)
(Figure 12-3, Page 12-2) .
1
491
Figure 12-6 Pull Brushes Away From Center of the Commutator End Cover
DISASSEMBLY OF THE STARTER/GENERATOR TO SERVICE THE
ARMATURE/COMMUTATOR
1. If the brushes are not removed, contact between the brushes and commutator as the commutator end cover is
being removed or installed could damage the brushes.
1.1. Lift the brush springs out of the notches in the brushes and pull the brushes back from the center of the
commutator end cover. The springs will rest on the sides of the brushes and help prevent them from sliding
towards the center of the cover
(Figure 12-6, Page 12-4) .
2. Remove the two bolts (20), and pull commutator end cover (23) free of the starter/generator housing (24) (Figure
12-2, Page 12-2) .
3. To separate armature (33) from output end cover (36), remove nut (41), lock washer (40), pulley (39), shaft key
(34), spacer (37), and bearing retainer screws (43)
(Figure 12-7, Page 12-5) .
Page 12-4 2009 FE 350 Maintenance and Service Supplement