Club Car FE 350, Дополнение к руководству по обслуживанию и ремонту

Страница: 97 / 280

TROUBLESHOOTING AND ELECTRICAL SYSTEM Test Procedures
11
TEST PROCEDURE 36 – Voltage At Taillight Socket
See General Warning on page 10-1.
1. Disconnect battery and spark plug wire(s). See Disconnecting the Battery – Gasoline Vehicles, Section 10,
Page 10-2.
2. Remove the taillight lens and remove the light bulb from the socket (Figure 11-56, Page 11-55) .
3. Using a multimeter set to 20 volts DC, place an alligator clip on the multimeter black probe. Connect the black
(–) probe to the ground terminal (where the black wire is attached) on the back of the taillight assembly.
See
following CAUTION.
CAUTION
• Do not allow the multimeter probe to touch the wire contact (+) and the metal housing (–) of the
light bulb socket assembly at the same time. An electrical short could occur which could blow the
fuse or cause wire damage.
4. To test brake light circuit, place the red probe on wire contact connected to the 18-gauge red wire.
5. To test taillight circuit, place the red probe on wire contact connected to the 18-gauge brown wire.
6. Connect battery and spark plug wire(s). See Connecting the Battery – Gasoline Vehicles, Section 10, Page
10-3.
7. To test taillights, place light switch in the ON position. The reading should be approximately 12 volts.
8. To test brake lights, place the light switch in the OFF position and press the brake pedal, making sure the park
brake is not pressed. The reading should be approximately 12 volts.
9. If the reading is incorrect, check bulb socket and wire continuity.
2m
20
m
200
m
2k
200
200
200 200
20
2
200
m
500
20k
200k
2000
k
1000
OFF
WAVETEK 5XL
V
V
V
A
! !
COM 200nA
MAX
1000 ---
750V
FUSED
1419
Figure 11-56 Taillight Socket Voltage Test
2009 FE 350 Maintenance and Service Supplement Page 11-55